(2) PDS-STN Stainless Steel Mounting Clips for Most 11mm Profiles
SKU: EX-KL1-CLIP-2
Description
A set of 2 clips for mounting a variety of our KL1 type LED Aluminum Channels with 0.44" mounting base. Works with a number of our aluminum channels for mounting to any drillable surface. Comes with 2 clips for a secure mounting solution that is simple to install. See a list of compatible extrusions that can be used with these mounting clips below. A minimum of two clips per 1M channel are recommended for a secure installation.
Reviews
|
Product Rating |
Write a Review |
|---|---|
|
|
|
|
- There are currently no reviews for this product
|
|
Questions
|
(2) Product Questions |
Have a Question? |
|---|---|
|
|
|
|
David L Beckwith asked: Sep 21, 2014 Will this work with Triple Wide Aluminum Extrusion. If not which one? Ecolocity LED Responded: Sep 22, 2014 David, thank you for your question. Unfortunately there are no mounting clips for the triple wide extrusions. They can be mounted by drilling through the extrusion and counter sinking a screw, or there are slots on the back side that will slide into a screw that is not fully sunk into the wall. This clip works on our EX-KL-1, EX-KL-3, and EX-KL-4 extrusions. |
|
|
Andrew asked: Dec 10, 2014 will the profiles 'clip' in and out of these clips, or do they have to be slid out? Thanks, Andrew Ecolocity LED Responded: Dec 11, 2014 Andrew, thanks for your question. The profiles definitely slide in to the clips easier than they do "clip" in. It is possible to clip in the extrusion to the clip but it will take some effort not to bend the clip too much to where the channel no longer fits inside of it. To answer your question, yes you can make the extrusion clip into the mount but it takes more effort and precision than sliding the channel into the clip. |
|
Products Used for Installation
